Flush Mounted Passive Infrared Dimming Detector
This is a miniature passive infrared occupancy detector which provides automatic control of lighting loads. This detector is suitable for use with both switched and dimming loads for LED luminaires.
The unit detects movement using a PIR sensor and then switches the load on, when an area is no longer occupied the load will switch off after an adjustable period of time. When the luminaires are lit and the area is occupied, the lamps will fade to a preset level. This detector can also be programmed for step back illumination to provide continuous low level illumination.
This product is designed to be mounted on a flat side of a luminaire. The detector should be sited such that room occupants are covered by the detection pattern at a recommended mounting height of 5m. Lowering the mounting height will reduce the detection range. The light level is being measured via a special photo diode with a spectral filter. This allows for precise light level measurement without interference from thermal radiation.
For order codes, please see individual luminaire product pages.
- Programming Handset
- Smart Programming Handset
- Basic Programming Handset
|Supply Voltage||220–240V AC, 50/60Hz|
|Power Consumption||On 2W Off 0.5W|
|Switch Input||Single momentary action|
|Digital Control Line||2 DSI / DALI|
|Control Devices||10 maximum|
|Maimum Output Cable Length||100m|
|Timeout||Adjustable up to 30 minutes, optional manual adjustment|
|Temperature||0°C to 60°C|
|Case Temperature||75°C maximum|
|Material||Flame Retardant ABS|
|Compliance and Standards||EN 61347-1|