ASENS-CHS5

Basic Programming Handset

ASENS-CHS5

The ASENS-CHS5 is a compact infrared handset used for basic programming of many of our integral and stand alone detectors.

The handset must be aimed directly at the device which requries control or programming. When programming a device it is only necessary to point the handset when uploading a new setting.

Order Code

  • ASENS-CHS5

Care

Replacing the Battery

The battery compartment is located on the bottom edge of the handset.

  1. Release the retaining lug to allow the battery holder to slide out
  2. Lift out the battery from the holder and insert a replacement battery (type CR2025 or equivalent), ensuring the correct polarity
  3. Slide the holder back in to the handset, ensuring the retaining lug clicks in to place

Cleaning the Handset

The exterior of the handset can be cleaned by using a damp cloth. Stubborn marks may be removed by using a mild detergent.

Detectors

  • Ceiling Mounted Microwave Presence Detector
  • IP Rated Ceiling Mounted Microwave Presence Detector
  • Adjustable Recessed Microwave Occupancy Detector
  • Adjustable Recessed Microwave Dimming Occupancy Detector
  • Recessed Microwave Occupancy Detector
  • Recessed Microwave Dimming Occupancy Detector
  • Compact Recessed Passive Infrared Occupancy Detector
  • Compact Recessed Passive Infrared Occupancy Detector
  • Recessed High Sensitivity Passive Infrared Occupancy Detector
  • Recessed High Sensitivity Passive Infrared Dimming Detector
  • Compact Recessed Passive Infrared Dimming Occupancy Detector
  • Batten Mounted Passive Infrared Presence Detector
  • Batten Mounted Passive Infrared Dimming Detector
  • Flush Mounted Passive Infrared Presence Detector
  • Flush Mounted Passive Infrared Dimming Detector
  • Short Arm Mounted Passive Infrared Occupancy Detector
  • Short Arm Mounted Passive Infrared Dimming Detector
  • Flush Mounted Microwave Occupancy detector
  • Flush Mounted Microwave Occupancy detector
  • Flush Mounted High Sensitivity Passive Infrared Presence Detector
  • Flush Mounted High Sensitivity Infrared Dimming Detector

Dimensions

ASENS-CHS5 Dimensions
D H W
4 86 40

Programming

The following parameters can be set using the ASENS-CHS5.

On / RaiseTurn lights on or raise level
Off / LowerTurn lights off or lower level
Walk testWhen set to on, this causes a red LED to flash on the sensor when it detects movement
Time OutOnce the detector is on, this sets how long the lights will stay on once movement has ceased
Lux on levelLight level setting to prevent the luminaire being switched on if the ambient light level is sufficient
Light levelTarget light level to be maintained by the lighting system
Lux off levelLight level setting to switch the luminaire off during occupancy
Load typeSets the ballast control protocol, DSI or DALI
SensitivitySensitivity level detecting movement
DefaultsReturns the detector to factory default settings
Burn-inSets how long the output will be set at 100% so that lamps can 'burn-in'
Presence / AbsenceChanges the detector between presence and absence detection

Note, this handset may include settings that are not used on the device being programmed. For advanced settings, the ASENS-CHSLCD can be used.

Technical

Weight17g
Battery3V DC lithium battery
CR2025 (supplied with the unit)
Infrared Range7m
Temperature0°C to 35°C
Humidity5% to 95% non-condensing
ConformityEMC-2004/108/EC
CE Marked